Mesh question

Answered

Comments

2 comments

  • Avatar
    Wishgranter
    Hi Nedo
    i just discovered the demo a few days ago, and i m very impresed with the speed and results with CR!
    thanx

    The Free Demo is over now, i could not test much the last 2 days doing Mesh from the Cloudpoints, and with the free Trial
    there is aboslutely no option to see Mesh? even without saving, or am i wrong here?
    no the demo not offer any mesh export. From November up to 31.1 it was a trial version with exports

    Can CR close holes in the Mesh? Is there an option in the full version? My Other question is there a smoothing the Mesh option.
    I hope you understand my questions.
    not now supported, but close hole can be done in many post work sw like Zbrush or Meshmixer and etc...
    0
    Comment actions Permalink
  • Avatar
    DotScott1

    Checking up on this. Is CR able to fill holes yet??... It's been a couple of years. 

    0
    Comment actions Permalink

Please sign in to leave a comment.