Export Mesh/Ortho to J-TSK

Answered

Comments

4 comments

  • Avatar
    Michal | CR
    Dear Paulina,
    you need to select "Project output" coordinate system instead of the "Grid Plane" from the "Coordinate System" during export of the model.

    But before you will export your model, you need to setup your "Project Output" coordinate system in "WORKFLOW -> Settings -> Coordinate Systems -> Project Output System" to the J-TSK coordinate system.
    0
    Comment actions Permalink
  • Avatar
    Paulina
    Hello Michal,

    I took your advice.
    I processed the whole project with GCPs in J-TSK and the project itself was in local system. When I changed it to J-TSK, which I don't think is proper, and exporeted the model according to what you've written, I received an error.[img][img][/img][/img]

    Could you please explain the meaning of Converted position, Actual position and Alignment report?
    If I work in a loca system, can I export the model in the same system?

    Thank you!

    Ragards,
    Paulina
    0
    Comment actions Permalink
  • Avatar
    Wishgranter
    Hi Paulina

    Do you get the invalid function call issue just at the beginning of the export or anywhere later ?
    0
    Comment actions Permalink
  • Avatar
    Paulina
    Hello,

    I start the export and after some time I get the error. So it is not in the beginning of the export.


    Wishgranter wrote:
    Hi Paulina

    Do you get the invalid function call issue just at the beginning of the export or anywhere later ?
    0
    Comment actions Permalink

Please sign in to leave a comment.