Comments

7 comments

  • Avatar
    Wishgranter
    Hi Bill
    yes this one is for small datasets.
    for larger ones is better to use a bit different scenario, so GCPs are added faster, will create and put here
    0
    Comment actions Permalink
  • Avatar
    bisenberger
    Thanks Wishgranter, looking forward to it.
    0
    Comment actions Permalink
  • Avatar
    Mika Moilanen
    Hello,

    Is it the same way how to add also the lidar pointclouds for aim to matching with photos? How the program can match the photo sets and lidar information?

    Br, mika
    0
    Comment actions Permalink
  • Avatar
    Wishgranter
    Hi Mika, yes same way

    but see how im spread the TIE points, as TIE points help to get a "rought" position of the components.
    If it set correctly, it will use even detected feature points for the final alignment

    if stuck somewhere let me know...
    0
    Comment actions Permalink
  • Avatar
    martinb
    Hi Mika,

    How the program can match the photo sets and lidar information?


    You need to scan with colors. Also make sure your scanner is calibrated. Sometimes color and intensity channels are pretty off, even 10px. System uses the color information primarily to connect photos and lasers.
    0
    Comment actions Permalink
  • Avatar
    bisenberger
    Wishgranter wrote:
    Hi Bill
    yes this one is for small datasets.
    for larger ones is better to use a bit different scenario, so GCPs are added faster, will create and put here

    Hi Wishgranter,
    I suspect that you are very busy, but I wanted to check if you were putting something together to show the scenario for adding GCPs faster for a larger project.
    Bill
    0
    Comment actions Permalink
  • Avatar
    martinb
    Hi Bill,

    here are the control point editor rules listed -
    Faster workflow for adding ground control points
    0
    Comment actions Permalink

Please sign in to leave a comment.