Convex alignment
Answered
Hi, we successfully built the project (a detailed model of the castle with approximately 1000 photos and 150*100 m). Now we have tried to align the other project (1700 photos and 2*3 km, it is the 2.5D model from UAV) and we have the problem with GCPs and their errors (it was alright in PhotoScan). We made the computation with setup the coordinate system of gcp and projected coordinate system like local and also S-JTSK East North, screens of results are attached (coordinates of gcps were shot with rtk gps). Except the errors the entire model seems very convex instead of the straighter surface.
https://lh3.googleusercontent.com/-hBlg ... 2/jtsk.jpg
https://lh3.googleusercontent.com/-1X-8 ... /lokal.jpg
https://lh3.googleusercontent.com/-hBlg ... 2/jtsk.jpg
https://lh3.googleusercontent.com/-1X-8 ... /lokal.jpg
-
Hi Bohumil
can make come screens so can see the image point detected on images ?
say 1+2+2+2 layout and put images in the 2D views and enable, like this one
https://www.dropbox.com/s/iswiqdtuo71gc ... 6.png?dl=0 -
Hi, thanks for your answer.
https://lh3.googleusercontent.com/-zMrJ ... point1.jpg
https://lh3.googleusercontent.com/-0Cch ... point5.jpg -
Hi, we tried to change alignment settings according to your printscreen, it wasn't successful (Bohumil wrote it yesterday).
Your last advice about the CONSTANT CALIBRATION has already been set there (it isn't possible to change it, isn't it?).
We tried also to set the "image down scale factor" to value 2 and weight of gcps up to value 100.
Further we tried also to set the lens distortion like unknown (not approximate). We attempted to compute all previously mentioned options .
Is it possible that there could be some problem with Exif data of the images? There is displayed an exclamation mark next to each image.
It seems that the alignment computation completely doesn't want to correspond with GCPs. -
Hi Jana
Its possible to send the dataset to milos.lukac@capturingreality.com so we can take a look on it here and say what can be done ?
Please sign in to leave a comment.
Comments
10 comments