Export .obj problem. My model is insite of some "box"

Follow

Charlie Cuverd

• March 26, 2018 15:19

Hi guys,

i need help to solve my problem. When i want to export my model .obj and open it in maya my model is insite of shell of polygons what is added automaticly.

Anybody know why that happened?

 

Thank you for help.

K.

0

• 

  ShadowTail

  • March 26, 2018 15:32

  That is normal.

  RC tries to create a watertight mesh.

  You can make the reconstruction area a little smaller inside RC and then use the filters to remove the box before exporting.

  Or you can do the post processing in 3rd party software.

  0

  Comment actions Permalink
• 

  Götz Echtenacher

  • March 26, 2018 16:02

  and yet again...   ;-)

  0

  Comment actions Permalink
• 

  Charlie Cuverd

  • March 26, 2018 16:14

  Thank you so much :)

  0

  Comment actions Permalink
• 

  Charlie Cuverd

  • March 26, 2018 16:14

  i thought it was bad setting on my side

  0

  Comment actions Permalink
• 

  Tom Foster

  • March 26, 2018 16:58

  ShadowTail said:

  "You can make the reconstruction area a little smaller inside RC and then use the filters to remove the box before exporting."

  So simple - so why can't RC have a button to do that automatically?

  Still leave a lot of rubbish (indeed seems to create lots of extra spikiness), which is arduous to remove within RC - is it so much easier in 3rd party software? (would that be MeshLab?)

  0

  Comment actions Permalink
• 

  Götz Echtenacher

  • March 26, 2018 17:03

  I don't think that Meshlab would do a much better job than RC with the new filters. I think your idea with a button for a slightly smaller box is quite good - there should be a setting for percent or absolute measurements. Why not make it a feature request? Should be rather simple to implement...

  0

  Comment actions Permalink
• 

  ShadowTail

  • March 26, 2018 17:07

  The problem with your type of scan is that RC cannot tell which side is the 'inside' for the watertight mesh and thus it picks one side (usually the wrong one), calls it inside and adds a (pretty) box that is only restricted by the reconstruction area.

  0

  Comment actions Permalink
• 

  aure

  • March 30, 2018 22:45

  In the new filtering tool (advanced one), you have one for selecting peripheral polygon.

  0

  Comment actions Permalink

Please sign in to leave a comment.