How to clean up model

Follow

Ron Knox

• May 22, 2020 20:27

How do I clean up the top right and left and bottom right corners up ? Do I use the clipping tool and if so how do I remove these bad area's out of my model 

TIA

Ron

0

• 

  Erik Kubiňan CR

  • May 25, 2020 10:22

  Hello,
  please navigate to the reconstruction tab and use lasso or rectangle to select the bad parts of your model, then once selected, hit Filter selection in the same tab. Please keep in mind that you can only do such operation after Reconstruction has been done. The sparse point cloud after alignment cannot be filtered.

  0

  Comment actions Permalink

Please sign in to leave a comment.