Is there a way to marge while keeping the alignment within the components?
Hi All,
I want to merge two components.
The two components are neatly aligned.
(One is from a laser scanner, the other is from a drone photo)
But there is almost no overlap. So I want to merge by control point.
When I merge at the control points, there is a misalignment within the components on the laser scanner side.
Is there a way to merge while keeping the alignment within the components?
-
Hello,
it is possible to lock relative camera positions within the component. Please unfold the list of images under the component, select them all (ctrl + A) and in the Selected inputs table change Lock pose for continue to Yes. This should prevent changing the camera positions in the next alignment and therefore prevent splitting up the component. -
Thank you Zuzana!!
I tried it.
Then, "Invalid or corrupted input data" is displayed and it is not aligned.
The overlap may be too low...
I will increase the control points and try again.
Thank you so much.
Please sign in to leave a comment.
Comments
2 comments