Mesh not corresponding to point cloud after being closed

Comments

2 comments

  • Avatar
    Götz Echtenacher

    Without screenshots, it'S really hard to say much.

    What I am certain about, though, is that the holes are already closed after meshing because RC needs watertight meshes. My guess is that your model was too big to be displayed as textured solid and you only looked at the colored pointcloud. With the simplification, it probably became small enough to be displayed as solid and that's why it seems as if it's only been introduced now.

    Leaves are really tough because they are so thin - are you sure that top and bottom have been aligned properly?

    0
    Comment actions Permalink
  • Avatar
    Olivier Lau

    @Götz Echtenacher : thanks for your answer and sorry for the delay replying; I actually have to double check a thing or two with this mesh so I'll eventually go back to it later. I guess that thin geometry is difficult to handle. However the lack of control in the mesh closing can really be a problem.

    0
    Comment actions Permalink

Please sign in to leave a comment.