Trimble Realworks e57 not importing all points

Completed

Comments

3 comments

  • Avatar
    Ondrej Trhan CR

    Hi Armorer1984,

    can you please contact our support (support@capturingreality.com) with this problem. It seems, that not all scan position were used in RC and we will need analyze this file. 

    0
    Comment actions Permalink
  • Avatar
    calvogeospatial

    Hi,

    I´m using Trimble TX8, which creates also TZF files from the scans and my workaround is going via Trimble Business Center as you can choose there when exporting to E57 wheter normal one or "structured" E57, which seems to be the one that RC supports.

     

    I hope this helps.

    Regards,

    Fernando

    1
    Comment actions Permalink
  • Avatar
    Armorer1984

    Ok, I found the solution in TRW.

    In TRW, the export needs to be done from the Registration mode. After selecting the entire project (or group of scans to export), the Export > Convert TZF Scans of Selected Stations option gives the ability to export PTX files that RC accepts with correct orientation.

    To get a cleaned or segmented set of stations to go to RC, one needs to use the cleaned and classified cloud and Create TZF Scans. Then you can go back to the registration tab, select the group of newly-created scan stations, and use the above method. Now if I can just get it to align to the photogrammetry and GNSS control, I'll be set.

    0
    Comment actions Permalink

Please sign in to leave a comment.