Unwrap settings is limited with numbers of polygons

Follow

KarbenUrbex

• September 03, 2021 21:09

Hi,

I have been facing a problem for several days.
I have a model that has about 500 million polygons after alignment.
So I divide it until it's only 60,000 polygons.

And when I want to unwrap the model and texture it, I get an error:

"Could not meet the unwrap requirements. Please increase the maximal texture count or the maximal texture resolution" while I'm in Fixed texel size !

Here are my parameters :

By trying with another model with 1 million polygons, however, it works well.

I also tried reprojection but the quality is still bad on the 60,000 polygon model.

I have the impression that the fewer polygons there are, the lower the quality of the texture is.

Need help please.

Thanks

0

• 

  Jakub Vanko RC

  • September 08, 2021 11:20

  Hello,

  I tried to reproduce the problem on a similar-sized dataset but I was unable to reproduce it. Please contact us through a technical inquiry on this website so we can file it a closely watch progress with the issue: 

  https://www.capturingreality.com/technical-inquiry

  It would really help us if you could share the dataset with us so we can reproduce the problem.

   

  0

  Comment actions Permalink
• 

  KarbenUrbex

  • September 08, 2021 12:43

  Thanks for your reply.

  I just send you a form by your link.

  You will find the entire project to download and more infos on the steps to produce the issue.

  Have a nice day,
  David

  0

  Comment actions Permalink
• 

  The-Runaway

  • September 09, 2021 18:44

  I have the same issue since I use fixed texel size. I had it for maybe 10/15 models at least.

  Only solution I found is to switch to maximum texture count and to be limited to less than 100% texture quality.

   

  0

  Comment actions Permalink
• 

  KarbenUrbex

  • September 10, 2021 06:38

  I tried your solution, and i didn't get the error but the texture quality is very bad.

  Here is a screen of the unwrap parameters and the result on the model :

  As you can see, i put a limit of 500 maximal texture count, but it only make 10 textures...

  0

  Comment actions Permalink
• 

  The-Runaway

  • September 10, 2021 07:51

  Did you use texture reprojection or simple texturing?

  When you did the texture on the 1M mesh, did you get 100% quality with 4k texture ? It might help to increase texture size to 8k if it's not.

  I noticed less of the " could not meet (...) requirement " when reprojecting texture on a simplified mesh with 8k fixed texel size unwrap than with 4k textures.

  But anyway, this is an issue I hope will be rectified soon as you could be limited to 60/70% texture quality whatever you do.

  0

  Comment actions Permalink
• 

  KarbenUrbex

  • September 10, 2021 09:58

  Texture reprojection is also limited, it reduce quality when reprojecting.

  It looks that quality percent is relative to poly count.

  I can get approximately 20% quality with 16k textures, but i need 4k textures.

  0

  Comment actions Permalink

Please sign in to leave a comment.