Help - Aligning Images halts progress around the 50% mark when using control points

Comments

2 comments

  • Avatar
    Kaizen77

    So restarting the program fixed the problem.  =D
    Can't get a good result though, I have the issue of "the projection error of the control point is over the limit".  RC doesn't care about how I see the control points should be.  It seems it might not be possible to overcome having good enough images.  I would figure what I have is good enough, but RC doesn't agree.

    0
    Comment actions Permalink
  • Avatar
    Ondrej Trhan CR

    Hi Kaizen77, this could be result of not so good alignment. How does it look in 1Ds view? How big errors did you get?

    0
    Comment actions Permalink

Please sign in to leave a comment.