.e57 Colorization

Comments

3 comments

  • Avatar
    Ondrej Trhan CR

    Hi Anton, did you use the Colorize or Texture option after model creation?

    0
    Comment actions Permalink
  • Avatar
    Anton WhyBIM.com

    I tried both. But since, I assume, there are no images in this dataset (just .e57 colored pointclouds), the resulting model comes out as green only. No other colors.

    In my regular photogrammetry sets where I have regular drone photos/videos with GRPs marked, I can do both, Colorize and Texturize to achieve the same result of colored XYZ point cloud on export. Colorize works faster, naturally, so I only texturize my models if I intend to export a mesh. For exporting XYZ color point clouds, Colorize is sufficient.

    But in the case with only .e57 colored point clouds in the initial dataset (no photos) I can’t retain the point cloud colors. All points turn green.

    hence, the original question.

    0
    Comment actions Permalink
  • Avatar
    Ondrej Trhan CR

    Hi Anton, you should be able to colorize the model just from E57 (it is not so good as from images but it is possible).

    What are your texture settings? What were the laser scan import settings?

    Please try to clear the cache manually as described here, and launch the application whilst holding down shift, and you should see the following options:

    Then select “make like a clean install”

    0
    Comment actions Permalink

Please sign in to leave a comment.