Thin part laser scan data + image data modeling question

추혜성

• September 06, 2022 06:19

hello. I am doing 3D modeling of buildings. If mesh data is generated during the modeling process by combining e57 data and image datathrough the Leica RTC360 equipment, holes keep appearing in the thin slate roof. When importing a separate laser scanner or when meshing, is there any part that needs to be adjusted? Please tell us.

 

• 

  Ondrej Trhan CR

  • September 06, 2022 09:04

  Hi 추혜성,

  this could be result of insufficient alignment. How were those datasets merged? Are you using georeferenced data? Are you using ground control points?
   

Please sign in to leave a comment.