
Jasper Mink
- Total activity 54
- Last activity
- Following 0 users
- Followed by 0 users
- Votes 3
- Subscriptions 23
Comments
Votes on activity by Jasper Mink Sort by votes-
Hi David, You did not mention if you edited RAW files or JPG files. In the case of using JPGs, you will likely get a more successful alignment without any edits. Editing JPGs can result in pixels t...
-
Hi Doron Kipper, What you're referring to is called tie-points. It's not necessarily a preview but rather a 3D visualization of the points that RC has matched in all the aligned images. Using tools...
-
Ah you've used the "Upload to Sketchfab" tool while letting RC optimize the model for Sketchfab? I'm uncertain in which way exactly RC optimizes the texture for Sketchfab. And I have not yet been s...
-
Hi Heiko, It says 42% of the optimal texel size. The optimal texel size is calculated based on the average GSD of the project.Assuming you created a single texture for the sketchfab model with a re...
-
Hi Heiko, In RC, when you look at the "Texture quality" percentage for this model, what does it say? The 3D viewer inside RC does not show the full uncompressed model quality but a down-sampled v...
-
I am experiencing the same issues. Taking over 5 hours to colorize 100k points (cropped from a 286mil point cloud) based of 2435 images. This doesn't seem right.
-
Hi Krasimir, I specifically meant the original images (all 350 or a part of it) so I can process them as well to see where your issues arises and why it's happening. @Sam thanks for the email!
-
Hi Tom, thank you kindly. I think it's important to help all types of users with a casual explanation. It'd be weird to assume that everyone reading these forums understands every terminology. More...
-
Hi Hape, Nice data set. For your issue I'd suggest to change the value of the 'Maximal vertices' count per part' from your value of 40 million to the default value of 5 million.
-
Hi Pjort, I agree with Götz here in that you could try increasing the value for the "Large triangle removal treshold" from the default value of 10 to some high number like 100 or 200 or even higher...