Avatar

James Brennan

  • Total activity 19
  • Last activity
  • Following 0 users
  • Followed by 0 users
  • Votes 1
  • Subscriptions 6

Activity overview

Latest activity by James Brennan
  • Avatar

    James Brennan created a post,

    Tie points not working

     I am trying to produce a model of a medieval wall. I am struggling to fuse images together with tie points. There is a lot of overlap on the images as well. I have put tie points on the laser scan...

  • Avatar

    James Brennan created a post,

    XYZ pointcloud export from RC

    I am having massive problems with exporting a point cloud from a RC model. It is of the roof of a building. The RC model is on OS GB coordinates. It looks correct and the bulding is lying flat on t...

  • Avatar

    James Brennan commented,

    Many thanks. Finally got there!  

  • Avatar

    James Brennan commented,

    Got it sorted. Imported the ground control first in a new project then added in images gradually with lots of saving. Now having a problem with texturing it! Anyone got any ideas? It comes up with ...

  • Avatar

    James Brennan commented,

    Thanks. I will have a go at doing that. There used to be a tutorial on aligning laser scan data with imagery on this web site I will see if I can see it. Out of the office now so will have another ...

  • Avatar

    James Brennan commented,

    Looks like you are right. It has made 2 components. One with the scan data in and one flipped one with the imagery in! For the alignment it does say its georeferenced.

  • Avatar

    James Brennan commented,

    I have changed that and then reimported the imagery and it has moved but still is weirdly oriented.

  • Avatar

    James Brennan created a post,

    Drone imagery orientation

    Answered

    I am struggling with a project using drone imagery and terrestrial laser scan data. After adding imergy to the scan data the model flips on its end! I have the imagery set to Unknown pose and the s...

  • Avatar

    James Brennan created a post,

    Texturing failing

    Answered

    I am trying to texture a ceiling. For some reason it is failing every time.  It is asking me to increase the maximal texture count or maximal texture resolution but I cannot enter anything into the...

  • Avatar

    James Brennan commented,

    Still struggling with this. I have just done another model. The photography was close and hi resolution and combined it with scan data fro a P40. Resolution wasn't great in the Ortho after using th...