
Pjotr van Schothorst
- Total activity 41
- Last activity
- Following 0 users
- Followed by 0 users
- Votes 4
- Subscriptions 16
Activity overview
Latest activity by Pjotr van Schothorst-
Pjotr van Schothorst created a post,
Creating 3D environments for architecture visualisations from drone generated images tutorial
I wrote a blog posting and step-by-step tutorial about creating 3D environments from drone generated images for architecture visualisations. Here the blog posting, and here the tutorial. I hope it ...
-
Pjotr van Schothorst commented,
For Sketchup, there is a plug-in called Artisan (http://artisan4sketchup.com/) to fine-tune mesh models. It would be great if this plug-in, or some of its features, became available for RC.
-
Pjotr van Schothorst commented,
Walking/cycling/driving through a street with a 360 camera set at regular 1-sec interval capture rate is not very complex or time consuming. Exploding these 360 images into multiple overlapping sma...
-
Pjotr van Schothorst created a post,
Create separate surfaces with different material IDs from selected areas
It would be nice if it was possible to create separate surfaces with different material IDs from selected areas, for example large grass areas. In a rendering program like Lumion, you can then assi...
-
Pjotr van Schothorst commented,
I found a tool to concert the equirectangular images into cubemaps. Below an example, almost 2k x 2k. Should be enough for reconstruction. But... since these cube images don't have any overlap, RC...
-
Pjotr van Schothorst created a post,
Accept 180-degree and 360-degree spherical images as input
PlannedI found elsewhere on the forum some discussions about using 360-degree images as input, but no feature request yet. So here it is. Please provide support for 180-degree spherical and 360-degree sph...
-
Pjotr van Schothorst commented,
strange. I copied the link again. Can you try again?
-
Pjotr van Schothorst commented,
Thanks! Here some renders made with Lumion, some of them with post-processing (artistic filters) with Topaz. https://photos.app.goo.gl/GopOHRAXFkJGaLzm1 you need a Google account to see that page, ...
-
Pjotr van Schothorst commented,
I found lout you can also cut out the trees looking top-down, much easier! The resulting holes in the ground below the tree can be fixed easily with the RC function "Check Topology", or "Fill Holes...
-
Pjotr van Schothorst commented,
This weekend I spent many hours improving the 3D mesh manually using MeshLab, an open source tool. Still some strange blobs visible, but the model is now good enough for its purpose: architectural ...