daniel.osullivan
- Total activity 20
- Last activity
- Following 0 users
- Followed by 0 users
- Votes 2
- Subscriptions 2
Comments
Votes on activity by daniel.osullivan Sort by votes-
Jonathan_Tanant just the default settings. Sometimes I run it with 'Force Component rematch' on and 'Merge Components only' on but thet seems to give me errors alot.
-
Jonathan_Tanant I was reluctent to touch them as im not 100% sure what they do. I have heard setting overlap to low can give good results on building scans though.
-
A draft align just seems to give me the same results. I realised however that If I run align again after it gives me all the componets with 5 or so images without deleting them it will then give me...
-
https://imgur.com/VIpbZNV.png https://imgur.com/BVhk6jK.png So no matter what I do I cannot seem to get my components to merge I have one component containing pictures from 2 walls and another 2 co...
-
How do these image markers look anything I could improve on before I drain all the printers? They are A4 size.
-
Tom Foster see I don't think the camera I’m using would be accurate enough to get intricate detail from a 40mm ball. I’m using blu tack to stick up these A4 bad boys as I can’t do anything damaging...
-
https://i.imgur.com/QASfo17.png Ive been getting some good results now using control points and deleting components that only contain 5 or so images. Ive managed to get a pretty good point cloud bu...
-
Just noticed that everything is getting split up into components. Each component has about 3 or 4 cameras in it. I doubt merging them together would do anything as they are orientated and posiitio...
-
Tom Foster Yeah i've actually printed out some a4 pages with different shapes that i'm going to stick on the walls and floor. It's just very weird that sometimes the image alignment works so well t...
-
Erik Kubiňan CR That doesnt seem to be the case for me. One of my runs it managed to get about 200 of the photos and add tie points. Then I hit align photos again and i was back to only 5 photos wi...