aonsen
- Total activity 29
- Last activity
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 11
Activity overview
Latest activity by aonsen-
aonsen commented,
Hello Lucia, I understand how the development process always takes longer then expected.Can you give any updates on the status of the next release? Will it have the LOD feature? Thanks!
-
aonsen commented,
As far as I understand, when using laser scan data in conjunction with photos, the geometry created by the photos is adjusted to fit the laser scan data. So in your case you might not see much of a...
-
aonsen commented,
Nino, it depends on the accuracy you require from the mesh you are generating. A mechanical shutter gives a much more precise image, which will translate to a more accurate mesh, since there is les...
-
aonsen commented,
What do you mean by "identify boundaries"? If you are you looking for mode detail in the mesh, then the photos need to have more details in those area, since the detail in the mesh is directly rela...
-
aonsen commented,
On the lens front, there's a lot or recommendations to stick with a focal range of around 35mm (from 24mm to 50mm), but it depends on what you're trying to capture. I've used super wide angle lense...
-
aonsen commented,
I've been trying to figure this out as well. I ended giving up and copied the data to a local SSD for the time being so I can process the data. What "Not Nick" said is true. Sequential read or writ...
-
aonsen commented,
Just remember to use "Brown4 with tangential2" for the Distortion Model when you align the images. The default "Brown3" didn't work for me.
-
aonsen commented,
Hello Davood, Here's some images. The texture looks very washed out and dull because the GoPro Fusion records the images in a flat color space. The GoPro Fusion Studio stitching app does some color...
-
aonsen commented,
I have used RC with images from GoPro Fusion with pretty good results. Just import the two raw images (not the stitched images) into RC. Experiment with the camera model (Brown4 + tangential worked...
-
aonsen created a post,
Working with laser scans and images
AnsweredI'm working with e57 laser scan files. These laser scan files have been registered in third party software and imported into RC as e57. Yet when I run the alignment tool in RC, the laser scan imag...