Olivier Lau

1. Community
2. General Discussion

Hi, I noticed the generated mesh was watertight closed, which is often desired, but sometimes not when we want to handle single-sided geometry. Also, closing holes can hide geometry on meshes with ...

• Olivier Lau
• October 03, 2018 19:41
• Edited
• 3 followers
• 2 comments
• 0 votes

1. Community
2. General Discussion

Hi, are there recommended settings to process thin surfaces such as leaves in order to avoid holes in the mesh? Thanks!

• Olivier Lau
• September 20, 2018 20:59
• Edited
• 3 followers
• 3 comments
• 0 votes

1. Community
2. General Discussion

Hi, when texturing meshes at different resolution into RC, I noticed the vertex density had a direct impact on the quality of the output texture. I.e. a mesh with 25 million polys (MP) would output...

• Olivier Lau
• September 12, 2018 15:33
• Edited
• 1 follower
• 0 comments
• 0 votes

1. Community
2. General Discussion

Hi, I am using the current version of RC 1.0.3.4987 which is supposed to support texture export, but I can't find this option in the UI, can someone please help? Thanks.

• Olivier Lau
• September 11, 2018 16:21
• 2 followers
• 2 comments
• 0 votes

1. Community
2. General Discussion

Hi, I have the model of a plant for which I took the top and underside of leaves. After reconstruction, I can see properly the two sides of the leaves in the RC 3D view, however when exporting the ...

• Olivier Lau
• August 14, 2018 10:29
• Edited
• 2 followers
• 2 comments
• 0 votes

1. Community
2. General Discussion

Hi, I would like to be able to remove points from the cloud after photo alignment before proceeding to the mesh reconstruction. I am concerned with the potentiality that removing unwanted points co...

• Olivier Lau
• July 26, 2018 11:09
• Edited
• 5 followers
• 15 comments
• 0 votes