
hazuki
- Total activity 13
- Last activity
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 3
Activity overview
Latest activity by hazuki-
hazuki commented,
Thank you! It worked! selection tab "lasso", "filter selection", "close holes", "clean model", "Unwrap", "Texture".
-
hazuki commented,
Sorry for any confusion with my reply. I want to try "split the project into the interior and exterior and then fit one into another in post", but I don't know how... How can I split the project?...
-
hazuki commented,
Thank you for your answer. ①I cut out the windows and use close holes. ②I model interior and exterior each. And I am connected afterwards. Is my understanding correct? could you inform me how to ...
-
hazuki created a post,
inside of the room turns black
I have a model of a house with a laser scanner and a photo.Most of the room is only for the laser scanner.And most of the outside is taken from the drone. When I texture it, the inside of the room...
-
hazuki commented,
Dear Erik I've just started using this software and tried a lot of things.Therefore, it is not an exaggeration to say that almost all settings have been changed. So I can't tell you what is causing...
-
hazuki commented,
I am sorry. I found the solution by myself. I've reset the settings. Thank you.
-
hazuki commented,
After normal detail, then I clicked texture bottom, error came up. I'm having this problem with other data too, do you know the solution?
-
hazuki created a post,
Can't I paste a texture if it contains laser scanner data?
I was able to successfully merge the components of the laser scanner and the components of the photo that I posted a few days ago.Next, I want to paste the texture to the finished component.However...
-
hazuki commented,
Thank you Zuzana!! I tried it.Then, "Invalid or corrupted input data" is displayed and it is not aligned.The overlap may be too low...I will increase the control points and try again.Thank you so m...
-
hazuki created a post,
Is there a way to marge while keeping the alignment within the components?
Hi All, I want to merge two components.The two components are neatly aligned.(One is from a laser scanner, the other is from a drone photo)But there is almost no overlap. So I want to merge by cont...