Wallace Wainhouse CR

1. Community
2. Feature Requests
3. Option to show a northarrow on Orthopicture export

Hi, we have a feature request "advanced possibilities for defining output ortho resolution" where a north arrow is mentioned as well as a scale bar, I will add you to that feature request to up the...

• View comment
• Wallace Wainhouse CR
• May 14, 2021 11:35
• 1 vote

1. Community
2. Community Workflows
3. Ortho in mixed building-vegetation areas

Hi Geovot, That's great you also found that setting, I should have mentioned that. Ideally bump it up incrementally till it works, a huge value like 1000 can also cause some issues.

• View comment
• Wallace Wainhouse CR
• April 30, 2021 09:40
• 0 votes

1. Community
2. Community Workflows
3. Ortho in mixed building-vegetation areas

Hi Geovot, If you have a hole in your model there, you could use this technique to fill the hole before texturing https://youtu.be/D2hFX9eAw1I?t=331  . Let me know if this is what you are trying to...

• View comment
• Wallace Wainhouse CR
• April 29, 2021 08:20
• 0 votes

1. Community
2. General Discussion
3. i want get super high quality human mesh

Hi,  I have removed your other comments as we do not allow duplicates on the forum. This sounds like a very interesting use case. Please let us know what kind of trouble you are having? Have you tr...

• View comment
• Wallace Wainhouse CR
• April 28, 2021 07:45
• 0 votes

1. Community
2. General Discussion
3. Comparing RC and Drone Deploy models...

Hi, The viewport in Reality Capture has a limit of one 16k texture. Please try to take a render of that view. If it still doesn't look right please check the quality of your texture by clicking on ...

• View comment
• Wallace Wainhouse CR
• April 27, 2021 13:15
• Edited
• 0 votes

1. Community
2. General Discussion
3. World File

Hi Andy, Please check if the output coordinate system in the applications settings is the same as the coordinate system for the rendered ortho projection. During mesh export make sure it is set to ...

• View comment
• Wallace Wainhouse CR
• April 26, 2021 09:47
• 0 votes

1. Community
2. General Discussion
3. Green mesh

Hi Everyone,  As there might be a few different issues in this thread, here is a summary of green mesh issues: This issue occurs when mesh was not calculated properly due to topology defect or Rea...

• View comment
• Wallace Wainhouse CR
• April 26, 2021 09:05
• 0 votes

1. Community
2. Community Workflows
3. Best solution for exporting a 3D model in kmz format

Hi Insepes 1, thank you for the feedback, I have created a feature request for this. If any other users would also like this feature please comment below and it will increase the priority of the fe...

• View comment
• Wallace Wainhouse CR
• April 26, 2021 08:35
• 0 votes

1. Community
2. General Discussion
3. Can only create preview quality models

Hi, try clearing the cache as described here, and then start the app whilst holding down shift, and select "make like a clean install" also, if still not working, please try with a console view, a...

• View comment
• Wallace Wainhouse CR
• April 26, 2021 08:31
• Edited
• 0 votes

1. Community
2. General Discussion
3. Comparing RC and Drone Deploy models...

Hi, what settings were you using in RC?

• View comment
• Wallace Wainhouse CR
• April 26, 2021 07:30
• 0 votes